Page 1 of 2.
Fire riser room requirements california.
In california all sprinkler water must go to sanitary to be treated before going to the ocean.
Where a door opens over a landing the landing shall be at least as wide as the door and at least 5 feet long.
Riser assembly shall have a minimum of 36 inches of clearance around the pipe.
Permanent artificial lighting is now required to be installed by the 2018 ifc ibc.
Thereafter the riser goes to floor 1 and above.
On the first floor there is a floor control valve with drain.
Fire pump and fire sprinkler riser rooms must be readily accessible at all times but can be locked if a key is available.
Fire pump and riser rooms shall be maintained to be no lower than 40 degrees fahrenheit with the heating device permanently installed.
Into the fire equipment room.
Fire pump and automatic sprinkler system riser rooms shall be provided with a door s and an unobstructed passageway large enough to allow removal of the largest piece of equipment.
The temperature in the room must be maintained at 40º fahrenheit or higher to ensure the piping and components do not freeze.
One side may be a minimum of 18 inches from a wall.
Water enters the building and goes through the backflow preventer and then into the fire pump both being located in the fire pump room.
Title 24 part 2 section 2 3303 i 1 and i 2 exception.
Integrated testing ifc ibc 901 6 2 nfpa 4 is a new standard for testing integrated fire protection and life safety systems.
Fire control rooms shall have a minimum dimension of 5 and not be less than 35 square feet in usable area.
The fire sprinkler riser shall be located on the outside wall between 12 and 18 from that outside wall and at least 12 from any other wall.
The fire equipment room shall be used for fire protection equipment and controls only.
2018 fire code expands requirements.
Where the door opens into the stairway of a smokeproof enclosure the landing need not have a length of 5 feet.
Where provided fire pump rooms and automatic sprinkler system riser rooms shall be designed with adequate space for all equipment necessary for the installation as defined by the manufacturer with sufficient working room around the stationary equipment.
The minimum size of the equipment room shall allow adequate firefighter access and mobility with the following minimum clearance requirements.